Tii 212 Manual do Utilizador descarregar pdf

P/N 92219901 • Rev B• 7/7/2008

Warranty: If this unit fails during the warranty period, contact tii customer service to authorize return. Unit may be returned prepaid.

Model 210/212

Home Networking Protection

Installation Note

Description

1. The series 210/212 In-Line Coax Lightning Surge

Protectors protect personnel and customer premises

equipment from lightning and power induced surges on

coaxial drop cable.

Designed for HFC of FTTC Broadband Network

Applications.

The series 210/212 is furnished complete and requires no

special tools for installation or maintenance.

The unit may be ordered with an indoor/outdoor enclosure

for installation.

Features

Figure 1

Installation

1. This combined installation note provides the description

and installation steps for the tii Series 210/212 In-Line

Coax Lightning Surge Protectors.

The unit is furnished complete with necessary hardware to

complete the installation.

National Electric Code Requirements: the protector

shall be installed per National Electric Code ANSI/NFPA

70, Article 800, Section C, and shall meet all other

applicable local safety codes.

Caution: Risk of shock if not installed in a listed

indoor/outdoor enclosure.

Notice: The product is to be installed in a listed enclosure,

which has been tested for applicable environment.

Cable Requirement: Using the right size cable will

ensure proper operation of the product. The center

conductor of coax cable used with this product should not

be larger than .040 inches (eg.RG59). Suitable adapters

must be used that have center pin conforming to .040

inches requirement (eg. RG6, RG11).

2. Series 210MF

Install a female to female F-Type connector for each coax

cable to be protected on a suitable grounding panel

(Figure 2-1) as needed or a female to female ground block

in a listed indoor/outdoor enclosure.

Attach coax protector male side to “F-Type” panel

mounted connector (Figure 2-2) ground block.

Attach drop antenna cable (Figure 2-3) to “Service” side of

the panel mounted connector/ground block.

Dress and secure cables so that incoming

service/antenna and customer/equipment cables do not

cross each other. Bundling of the cables should be

avoided.

Series 212F

Mount protector to an appropriate ground block using

supplied hardware (Figure 3-1).

Attach drop cable to “SERVICE” side of the protector as

shown in Figure 3-1.

Attach customer cable to “CUSTOMER” side of the

protector as shown in Figure 3-1.

1 2

Installation Note 1

Resumo do Conteúdo

Página 1 - Installation Note

P/N 92219901 • Rev B• 7/7/2008 Warranty: If this unit fails during the warranty period, contact tii customer service to authorize return. Unit may be

Página 2

Strip and insert a #12 (minimum) ground wire into the hole provided on the surge protector (Figure 3-1). Turn screw until wire is compressed and tight

Modelos relacionados 210

Comentários a estes Manuais

Sem comentários

Tii 212 Manual do Utilizador

Consulte online ou descarregue Manual do Utilizador para Equipamento Tii 212. Tii 212 User Manual [it] [de] [fr] Manual do Utilizador

Resumo do Conteúdo

Modelos relacionados 210

Comentários a estes Manuais

Manuais e produtos relacionados com Equipamento Tii 212